Replacing The Filter; Replacing The Fuses - Checchi & Magli WOLF PRO Bedienungs- Und Wartungsanleitung

Replacing the filter

Removal stage
Proceed as outlined below.
1) Drain the tank completely.
2) Undo the ring nut (A).
3) Loosen the clamp (B).
4) Remove the parts (C).
5) Unscrew the filter (D).
6) Unscrew the fitting (E).
Fitting stage
Proceed as outlined below.
1) Screw the fitting (E).
2) Screw in the new filter.
3) Fit the parts (C) into the fitting.
4) Screw the strap (B).
5) Tighten the ring nut (A).

Replacing the fuses

Before replacing the blown fuse, elimi-
nate the cause of it blowing.
Replace the interrupted fuse only with a
fuse with the same characteristics.
Proceed as outlined below.
1) Turn the main cut-off switch (D) to
the "OFF" position.
2) Disconnect the plug (E).
3)
Undo the screws (A).
4)
Remove the cover (B).
5)
Open the fuse holder (C).
6)
Remove the fuse.
7)
Fit the new fuse.
8) Close the fuse holder (C).
9) Position the cover (B).
10) Tighten the screws (A).
English language
INFORMATION CONCERNING REPLACEMENTS
UN41-0938UA
C
B A
D
UN41-0940UA
12
E
C
B
A
D
E
Use and maintenance
8