Initial Setup; Unpack; Unpack The Accessory Kit; Connecting Oil Bottles And Uv Dyebottles - Bosch ACS 661 Originalbetriebsanleitung

4.

Initial Setup

4.1

Unpack

1. Remove the bandings from the box.
2. Remove the top carton infold, the molded pulp tray,
and the angle boards.
3. Remove the sleeve from the bottom carton infold.
4. Gently roll the unit forward and off the pallet, avoid-
ing any sudden shocks to the ACS 661.
WARNING: To prevent personal injury while
working with refrigerant, read and follow
the instructions and warnings in this manu-
al, and wear protective equipment such as
goggles and gloves.
4.2

Unpack the Accessory Kit

Unpack the accessory kit from the box, and remove the
plastic packaging.
Accessory Kit
Calibration
Weight 533 g
Gaskets (3)
4.3 Connecting oil bottles and UV dye-
bottles
i
Pay attention to the symbols on the service flap
showing the type of bottle. Pay attention also to
the symbols (PAG oil and POE oil) on bottles them-
selves.
!
To avoid chemical incompatibilities with the internal
components of the ACS 661, use only UV dyes and
oils approved by the vehicle manufacturer. Problems
resulting from the use of non-approved UV dyes and
oils will cancel the warranty.
Robert Bosch GmbH
Tank Fill Hose
Adapters (3)
Pouch containing the user
manual and Material Safety
Data Sheets (MSDSs).
Initial Setup | ACS 661 | 37
1. Fill the fresh PAG oil bottle or POE oil bottle with
proper compressor oil.
2. Connect the fresh PAG or POE oil bottle to the top
quick release coupling when requested by the ACS
software.
3. Fill the UV dye bottle with UV contrast medium.
4. Connect the UV dye bottle to the middle quick re-
lease coupling.
5. Connect the used oil bottle to the bottom quick
release coupling.
4.4

Power Up

1. Unwind the power cord from the handle, and plug it
into a correct voltage, grounded outlet.
2. Position the ACS 661 so the plug and the power switch
are of easy access for the operator. Verify the fan vents
on the rear of the ACS 661 are not obstructed.
3. Lock the front wheels.
4. Turn the master switch clockwise (CW) to turn the
ACS 661 ON.
"
The ACS 661 launches into the initial Setup mode.
4.5

Select Language

The operator selects the language for the screen
prompt displays. English is the default language.
1. Use the Up or Down arrow key to toggle through the
available languages one line at a time.
2. Press F1 to set the selected language.
4.6

Select Units

The operator sets the display for units of measure. Met-
ric is the default.
1. Use the Up or Down arrow key to toggle Imperial or
Metric units.
2. Press F1 to choose the displayed unit of measure.
4.7

Set Date and Time

Use the arrow keys to move the cursor. Use the keypad
to modify the information displayed.
1. Use the Up or Down arrow keys to select which item
to change: day, month, year, or time.
2. Use the multi-tap interface on the numeric keypad to
modify the information:
3. Press F1 to save.
en
|
SP00D00171 2019-07-02