21.0- PARALLELOGRAM
It consists of:
- DOBLE ARTICULATED JOINT;
makes the adaptation to the ground
easier.
- FLEX WHEEL; adjustable in height
through handwheel(fig. 14.H).
It is possible to change the weight
on the press wheels by adjusting
both the reversible spring (fig. 14.F)
using the hanswheel (fig. 14.G) and
the spring (fig. 14.E).
22.0- PLANT CONTROL
It is possible to adjust the mobile
guard height (fig. 15):
- unscrew the nut(fig. 15.A) and
move the guard (fig. 15.E).
The phase can be changed with
respect to the ejector:
- unscrew B and C, turn the lever D
as shown in fig. 15.
23.0 - DISTRIBUTOR HALF-
CUP OPENING
According to the type of plant and speed
of rotation, the plants descending from
the distributor (fig. 16) may hit the mouth
of the dropping tube (fig. 16.A) sideways
on, resulting in a drop which is not
straight.
To correct this situation adjust the
opening lever (fig. 16.B) by turning the
screws
(fig. 16.C) until the plants drop down the
centre of the tube (fig. 16.A).
-turn clockwise to DELAY
-turn anticlockwise to ADVANCE
Secure the screws properly (fig. 16.C).
24.0- PLOUGHSHARE
FORROW OPENER
It can be easily opened to be cleaned.
Unloosen the wing nut (fig. 17.A) and
push the ploughshare forward (fig. 17.B)
by pressing the safety lever (fig. 17.C),
lower the ploughshare. To close it: bring
the ploughshare back on a horizontal
position, push then backward and lock
the wing nut A.
48
TEX DRIVE BEST
H
D
E
A
E
A
NO
A
B
G
F
FIG. 14
B
C
D
FIG. 15
B
C
A
FIG. 16
A
C
FIG. 17