Checchi & Magli BABY COMPACT Bedienungs- Und Wartungsanleitung Seite 82

Replacing the slider
UN41-0356AL
Danger - Warning
During disassembly, watch out for the elasticity of
the slider since, when it is released from the rail, it
springs back to the starting position (straight) and
could cause injury.
When the slider wears down to a thickness of 6 mm, it
must be replaced.
Proceed as outlined below.
Disassembly
1) Secure the slider to the skid using suitable clamps.
2) Unscrew the nuts and remove the screws securing
the slider to the skid.
3) Slowly release the slider and remove it from the skid.
Scrapping the work vehicle
Scrapping operations must be handled by specialised
personnel with suitable skills for the job.
The person authorised to scrap the machine will have
English language
INFORMATION CONCERNING REPLACEMENTS
Assembly
1) Fit the new slider into the guide (A).
2) Tighten screws (B) and nuts (C).
3) Position the slider against the guide and secure it in
position using suitable tools.
4) Secure the slider to the guide using the relative
screws and nuts.
5) Remove the tools used to temporarily secure the slid-
er.
to dismantle and separate the components according
to the type of constituent material and dispose of them
separately, in accordance with applicable laws.
38
8
C
B
A
Use and maintenance