Parkside PRM 1800 B2 Originalbetriebsanleitung Seite 27

you or going backwards.
There is a risk of personal inju-
ry.
• Switch on the equipment care-
fully and in accordance with
the directions in these instruc-
tions. Ensure suffi cient distance
between feet and the rotating
blades. Contact with the cutter
can result in injury.
• When starting or turning the
motor on, the lawnmower
must not be tilted, unless it is
required to lift the lawnmower
in the process.In doing so, tilt it
only as far as absolutely neces-
sary and lift it only on the side
facing away from the user. In
this case, tilt the equipment by
pressing down the handle bar
such that the front wheels of the
equipment are raised. Always
check that both hands are in
the working position before
returning the equipment to the
ground.
• Do not work without the grass
bag or collision guard. Keep
away from the ejection hole at
all times.
• Do not start the motor when
standing in front of the emission
duct.
Caution! Danger! The blade
continues to run after switching
off. There is a risk of injury.
• The equipment is not to be lifted
or transported while the motor
is running. Switch off the equip-
ment if it has to be tilted in
transit, when crossing surfaces
other than grass, and when the
equipment is being transported
to and from the surfaces to be
mowed.
• Always keep the grass ejection
hole clean and clear. Remove
cut material only when the
equipment is stopped.
• Do not leave the equipment un-
attended in the workplace.
• Do not work with equipment
that is damaged, incomplete, or
has been modifi ed without the
authorisation of the manufac-
turer. Do not use the equipment
with damaged safety devices or
screens or with missing safety
equipment such as defl ection
and/or grass collection devices.
• Do not overload the equipment.
Work only within the speci-
fi ed power range and do not
change the regulator settings on
the motor. Do not use low-pow-
ered machines for heavy work.
Do not use your equipment for
purposes other than those for
which it is designed.
• Do not use the equipment near
infl ammable liquids or gases.
Non-observance will result in a
risk of fi re or explosion.
• Do not lift or carry the equip-
ment when the motor is running.
Risk of injury from cuts.
• Switch off the equipment and
disconnect the plug. Make sure
that all moving parts have come
to a complete stop:
- Whenever you leave the ma-
chine,
- Before cleaning the ejection
hole or removing blockages,
- When the equipment is out of
use,
GB
27