Charging Instructions - Rapid BGX7 Betriebsanleitung

LED Red LED green

CHARGING INSTRUCTIONS

– Connect the USB cable onto charger and micro USB socket at the
back of the tool
– Connect the charger to the mains.
– The LED on the glue gun will fl ash red during the charge., and will
turn to fi x green when battery is fully charge
– During the process of charging, the charger and glue gun can
become warm, this is normal.
LED Red LED green
Operation / Usage
Switch ON for approx 2 sec.
Green LED will fl ash for approx 20 sec.
(pre-heating)
Applicator ready for Use.
Press ON/OFF button for approx 2 sec to
switch OFF the applicator when job is fi nish
No use/glueing for approx 3 min :
glue gun automatically switches OFF for
safety
Press button ON to re-start
Red and green LED fl ashes alternately after
glue gun has been used for approx 25 min.
Battery almost empty applicator can now
only be used for approx 5 min
Red fl ash only or no more LED : battery is
empty, re-load it by using USB charger
Charging with USB charger
14