Heiniger PegasusMidi Bedienungsanleitung Seite 19

If the appliance has fallen into water, pull out the power supply unit immedi-
ately, and only then remove the appliance from the water. Do not use the
appliance again, and have it checked by a specialist workshop.
Protect the appliance from moisture, water drops and water splashes.
The appliance, the connecting cable, the charging station and the power sup-
ply unit must never be immersed in water or other liquids.
If liquid gets into the appliance, remove the power supply unit immediately.
Have the appliance checked before reusing.
Never touch the appliance with wet hands.
Do not rinse it under running water.
After use, pull out the power supply unit. The proximity of water represents a
hazard even when the trimmer is not being charged.
Installation of a residual current device (FI/RCD) with a rated residual operat-
ing current of no more than 30 mA into the electrical circuit is recommended
to provide additional protection. Ask your electrician for advice. The installa-
tion should only be carried out by a qualified electrician.
DANGER! Risk of electric shock
The following safety instructions apply to the connected charging station, and
to the appliance when it is being operated with the power supply unit.
Check the appliance and the connecting cable regularly for damage. Do not
use the appliance if the appliance or the connecting cable has any visible
damage, or if the appliance has previously been dropped.
Only connect the power supply unit to a properly installed and easily accessi-
ble power socket, whose voltage corresponds to the specifications on the
type plate. The wall socket must still be easily accessible after the appliance
is plugged in.
Lay the connecting cable such that no one can step on it, get caught on it, or
trip over it.
Please be careful not to damage the connecting cable:
– Keep the connecting cable away from hot surfaces and sharp edges.
– Ensure that the connecting cable cannot be trapped or crushed.
– Do not wrap the connecting cable around the appliance. The cable may
break.
To pull the power supply unit out of the power socket, always pull on the
power supply unit, and never on the connecting cable.
Never attempt to remove dust and foreign objects from inside the appliance
using pointed objects.
Pull the power supply unit out of the power socket, ...
– after every use,
– after each charging process (does not apply to charging station),
– if there is a fault,
– before oiling the appliance,
– before you clean the appliance and
– during thunderstorms.
Ensure that the power supply unit cannot be plugged in again during clean-
ing.
In order to avoid any hazards, do not make modifications to the appliance.
You also must not replace the connecting cable yourself. Repairs must be
carried out exclusively by your authorised customer service centre.
Use only original spare parts, which you can order from the customer service
centre (see the back of these user instructions). If the connecting cable is
damaged or crushed, both it and the power supply unit must be completely
replaced.
ENGLISH 17