Beko BBCW13400DX Bedienungsanleitung Seite 47

7.2 Cleaning Accessories
Do not put the product accessories in a
dishwasher unless otherwise stated in the
user's manual.
7.3 Cleaning the Control Panel
• When cleaning the panels with knob-
control, wipe the panel and knobs with a
damp soft cloth and dry with a dry cloth.
Do not remove the knobs and gaskets
underneath to clean the panel. The con-
trol panel and knobs may be damaged.
• While cleaning the inox panels with knob
control, do not use inox cleaning agents
around the knob. The indicators around
the knob can be erased.
• Clean the touch control panels with a
damp soft cloth and dry with a dry cloth.
If your product has a key lock feature, set
the key lock before performing control
panel cleaning. Otherwise, incorrect de-
tection may occur on the keys.
7.4 Cleaning the inside of the oven
(cooking area)
Follow the cleaning steps described in the
"General Cleaning Information" [} 45] sec-
tion according to the surface types in your
oven.
Cleaning the side walls of the oven
The side walls in the cooking area can only
be covered with enamel or catalytic walls.
It varies by model. If there is a catalytic
wall, refer to the "Catalytic surfaces" [} 46]
section for information.
If your product is a wire shelf model, re-
move the wire shelves before cleaning the
side walls. Then complete the cleaning as
described in the "General Cleaning Informa-
tion" [} 45] section according to the side
wall surface type.
To remove the side wire shelves:
1. Hold the side wire shelf at the bottom.
Pull it down and free it from the bottom
slots.
2. Pull the side wire shelf in the opposite
direction of the side wall.
3. Completely remove the side wire shelf
by pulling it up.
7.5 Cleaning the Oven Lamp
In the event that the glass door of the oven
lamp in the cooking area becomes dirty;
clean using dishwashing detergent, warm
water and a soft cloth or sponge and dry
with a dry cloth. In case of oven lamp fail-
ure, you can replace the oven lamp by fol-
lowing the sections that follow.
Replacing the oven lamp
General Warnings
• To avoid the risk of electric shock before
replacing the oven lamp, disconnect the
product and wait for the oven to cool.
Hot surfaces may cause burns!
• This oven is powered by an incandes-
cent lamp with less than 40 W, less than
60 mm in height, less than 30 mm in dia-
meter, or a halogen lamp with G9 sock-
ets with less than 60 W power. Lamps
are suitable for operation at temperat-
ures above 300 °C. Oven lamps are avail-
able from Authorised Services or li-
censed technicians. This product con-
tains a G energy class lamp.
• The position of the lamp may differ from
that is shown in the figure.
• The lamp used in this product is not
suitable for use in the lighting of home
rooms. The purpose of this lamp is to
help the user see food products.
• The lamps used in this product must
withstand extreme physical conditions
such as temperatures above 50 °C.
If your oven has a round lamp,
1. Disconnect the product from the elec-
tricity.
EN / 47
EN
DE