Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Commissioning
No plugs
Without plugs, use the cable grommet to connect your load and, if applicable, your
PV modules to the power solution.
Use the appropriate cable grommet (diameter) for your cables.
Connect the PV modules to the built-in charge controller. Read the operating
instructions of the charge controller.
Depending on the configuration of your ProEnergyCase, the load is connected to
the charge controller, the Battery Protect or the DC-DC converter. Use the
enclosed wiring diagram as a guide.
Use the cable ducts on the inside of the ProEnergyCase to route the cables neatly.
If the outer bushings are not used, the dummy grommets must be used to
prevent soiling of the bushings. These can be found in the EFOY
ProEnergyCase accessories.
The solar charge controller - or, depending on the configuration, the Battery
Protect - has integrated deep discharge protection for the battery. Bear this
in mind when connecting loads.
Danger of short circuit!
Keep the metal fuel cartridge connectors of the EFOY Fuel Manager away from
the battery terminals.
Make sure that the fuel cartridge connections of the EFOY Fuel Manager are
neatly fastened in the clip holders and are not lying around freely in the
ProEnergyCase. This could lead to a short circuit when installing the battery.
To install the EFOY Fuel Manager, please proceed as follows:
Page 55
Werbung
