Show Scale Type (Analog/Digital) - HBK WTX110 Bedienungsanleitung

Display
Input 1 ... 4
Output 1 ... 4
10.7

Show scale type (analog/digital)

Access the menu group via Service Mode ↓ Interface → General →
Calibration → Config. ↓ Config Scale. For more information also see the
Navigation Pilot.
Display
Config. Scale
WTX110
OPERATING MODES: OVERVIEW
Key Explanation
Off
Tare
Zero
Rec.weight On setting the input ("1"), the
Off
Manual
LV1
LV2
LV3
LV4
Status
Key Explanation
View the scale type.
Analog scale (WTX110-A)
ADM
Digital scale (WTX110-D)
HBM
No function
On setting the input ("1"), taring is
performed
On setting the input ("1"), zeroing is
performed
measurement is written to the alibi
memory and printed, if so enabled
No function
Manual set/reset via
Service Mode/Test; see section
21.5.1, page 208
Limit value 1
Limit value 2
Limit value 3
Limit value 4
Scale status; high level = OK,
low level = error
135