HBK WTX110 Bedienungsanleitung Seite 124

S
If too many items are placed on the scale during optimization, an error message
appears.
S
10 is suggested as the number of reference items, but you can change this.
S
It is possible to count either into an empty container or out of a full container.
S
You can set switching points S1 and S2 in Supervisor Mode to enable tolerance
checking; see section 7.3, page 70.
S
Set the outputs via Service Mode → Application ↓ General Setup →
Digital IO → Output 1 or Output 2; see section 12.1, page 156.
S
You can lock the Totalize (With totals?) function via Supervisor Mode; see
section 7.3, page 70.
Important
If an optical tilt sensor is connected, Input 2 is no longer available for operating mode
functions.
122
OPERATING MODES: OVERVIEW
WTX110