Changing А Needle; Connecting The Machine To The Power Source - EFFEKTIV TRIUMPHATOR 2500X Benutzerhandbuch

CHANGING А NEEDLE
RU
14
Turn off at the power switch
То remove: Lower the presser foot
and raise the needle(s) to its/their
highest position. Take the needle
changing tool out of the accessory
Ьох and push it up over the needle
as far as it will go. Loosen (but do
not remove) the needle' s retaining
screw with the allen key and pull
the needle out from below.
Tо insert: lnsert the needle in hole
А of the needle changing tool so
that the flat side В of the needle
is opposite face of the tool. lnsert
the needle as far as it will go into
the needle holder (you may have
to push а little harder Ьу hand)
and tighten the retaining screw.
Remove the needle changing tool.
Needle Needle Туре ot
System Size Fabrics
EL х 705 11-14 Light to
medium
weight fabrics
(75-90)
such as silk,
cottons, shirts,
blouse fabrics,
stretchy
fabrics, denim
& etc.
EN USER MANUAL

CONNECTING THE MACHINE TO THE POWER SOURCE

Before connecting the power supply, make sure that the voltage and
frequency shown оn the machine is conforming with your electrical power.
Place machine оn а stable surface.
1. Connect the power line cord to the machine Ьу inserting the 3 pin plug
into the power cord socket.
2. Connect the power line plug to the electric outlet.
3. Turn оn the power switch.
4. The sewing lamp will light up when the switch is turned оn.
То disconnect, turn the power switch to the off position, then remove plug
from outlet..
TRIUMPHATOR 2500X
RU
15