Safety; General Safety Notes - Kessel Aquapump Medium LW 600 Einbau- Und Betriebsanleitung

2

Safety

The following symbols are used:
Icon
WARNING
CAUTION
2.1

General safety notes

The accident prevention regulations, the applicable standards and directives as well as the regulations from the local energy
and supply companies must be observed during the installation, operation, maintenance and repair of the system.
NOTICE
Disconnect system from energy sources!
Ensure that the electrical components are disconnected from the electrical power supply during the work.
WARNING
Live parts!
Heed the following points when working on electrical cables and connections:
The national safety regulations apply for all electrical work on the system.
The system must be supplied through a residual current protection device (RCD) with residual current of not
more than 30 mA.
The float switch unit are live and must not be opened.
Make sure that the electric cables as well as all other electrical installation components are in a faultless condition. In case of
damage, the system may on no account be put into operation or must be stopped immediately.
WARNING
Danger due to overvoltage!
Operate the system only in buildings in which an overvoltage protection system (e.g. surge arrestor, type 2 per
VDE regulations) is installed. Interference voltage can seriously damage electrical components and lead to sys-
tem failure.
CAUTION
Hot surfaces!
Pumps can become very hot during operation.
Wear protective gloves or allow the pump to cool.
WARNING
Transport risk / system's own weight!
Check the weight of the system / system components (see "Technical data", page 30).
Pay attention to correct lifting and ergonomic factors.
24 / 118
WEEE icon, product governed by RoHS Guideline
Warns of a hazard for persons. Ignoring this warning can lead to serious injuries or death.
Warns of a hazard for persons and material. Ignoring this
warning can lead to serious injuries and material damage.
The product fulfils the requirements for potentially explosive atmospheres (ATEX)
Installation and operating instructions
Meaning
Isolate device!
Observe the instructions for use
CE marking
Warning, electricity
328-198_03