Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
Switch the device on via the power switch. Connect the remote control with the remote control-socket.
After a certain warm-up time, the device is ready to operate. Then the stand-by lamp (green LED) of the
remote control lights up. By operating the smoke switch on the remote control the smoke emission starts. It
may happen that the stand-by lamp turns off and the smoke emission stops. In this case the device is
heating up again, and will be ready to operate in approx. 1-2 min. This process guarantees an appropriate
vaporization temperature and the best smoke emission possible. The temperature is regulated by a high
quality thermostat.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.
DMX-protocol
Channel 1 – Fog volume
DMX-value:
Volume (%)
0 - 255
Gradual adjustment of the fog volume from 0 to 100 %
CLEANING AND MAINTENANCE
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
Clean the escape nozzle frequently from smoke fluid residues.
Cleaning the heating element
The heating element should regularly be cleaned every 30 operational hours in order to avoid clogging. Use
smoke machine cleaner available at your dealer.
Procedure:
Fill cleaner into empty tank. Run the machine several times in a well-ventilated room only. The number of
repititions depends on the pollution level of the vaporizing elements. After use clean all remaining cleaner
and rinse the tank thoroughly.
The EUROLITE smoke fluids we recommend are non-hazardous to the environment and can be disposed of
via the sewage system.
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
15/16
00064957.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
