Dmx Operation - EuroLite LED Silent PAR 6 Bedienungsanleitung

DMX operation

The device has two different DMX channel modes. The Control Board allows you, as described above, to
assign the DMX channel mode.
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED Silent Par 6 QCL Floor will respond to the controller.
If you set, for example, the address in the 11 channel mode to channel 12, the device will use the channel 12
to 22 for control.
Note: Please, be sure that you don't have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX-chain. If several device are addressed similarly, they
will work synchronically.
For setting the desired starting address please press the MENU button until the display shows „d11--" or
„d.6--„. Press the ENTER button to confirm the desired DMX channel mode. The display shows: d001. Set
the desired address via the UP or DOWN button. Please press the ENTER button again to confirm.
Now you can start operating the LED Silent Par 6 QCL Floor via your lighting controller.
Note:
The state of the DMX connection is shown on the display of the device.
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the DMX
data is received at the DMX-input, the last dot of address code will flash. If there is no data received at the
DMX-input, neither the dot will flash.
No flashing appears if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective.
- the cable or connector is defective or the signal wires are swap in the input connector.
Functions in DMX mode
6-channel mode
Channel
CH1
CH2
CH3
CH4
CH5
CH6
Value Function
Red
000 – 255 Red 0 - 100 % increasing
Green
000 – 255
Green 0 - 100 % increasing
Blue
000 – 255 Blue 0 - 100 % increasing
Warm white
000 – 255
Warm white 0 - 100 % increasing
Dimmer intensity
000 – 255 Gradual adjustment of the dimmer intensity from 0 to 100 %
Strobe
000 – 000 No function
Sound control, 15 colors
001 – 005
On
006 – 010
011 – 255 Strobe effect with increasing speed
27/32 00143647, Version 1.0