Master/Slave Operation - EuroLite LED Silent PAR 6 Bedienungsanleitung

pr21
pr22
pr23
pr24
pr25
8 F--- F000-F255
9 C--- C000-C255
10 J--- J000-J255
11 S--- S000-S255
d on
12 dp---
d oF
dr-0: Response characteristics of LEDs
dr-1: Response characteristics of
dr-2: Response characteristics of
13 dr--
dr-3: Response characteristics of
dr-4: Response characteristics of

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the desired mode for the master device, as described in chapter Control Board.
Set each slave device to any DMX address. The devices set in this manner can now be controlled by the
master unit.
Light cold white
Pure white
Pink white
Creme white
Warm white
halogen lamps, very fast
halogen lamps, fast
halogen lamps, middle
halogen lamps, slow
Strobing colors (color setting via menu r---,
g---, b--- and n---)
(with increasing speed)
Fading colors
(with increasing speed)
Switching colors
(with increasing speed)
Sound controlled mode
(with decreasing sensitivity)
Display stays on
Display goes off
Dimmer speed (step response)
26/32 00143647, Version 1.0