Determination Of The Type Of Video Transmission - G&D ControlCenter-IP-XS Installationsanleitung

4. In the menu, click on
Matrix systems > [Name] > Target modules
5. Select the end device to be unpaired.
ADVICE: Multiple selection of devices is possible.
6. Click on Unpair device

Determination of the type of video transmission

In the default setting, the target modules (
cast to the user modules (
This option allows users with »Target multi access« right to connect to a computer
to which another user is already connected.
IMPORTANT:
The multicast streams are controlled by the network switches and
enable efficient distribution of the streams to multiple recipients at the same time.
Please note the requirements for the network switch for sending the video streams
via multicast. Refer to the Installation Guide for detailed information.
Alternatively, you can specify that the target modules (
streams via unicast to the user modules (
The connection of a user to a computer to which another user is already connected
is not possible in this mode (message:
NOTE: This option places significantly less demands on the network switch.
You can define the type of video transmission system-wide. The system-wide setting
is applied by default by all target modules. In addition, you can specify the type of
video transmission individually for each target module.
How to configure the system-wide multicast or unicast video transmission
setting:
1. Press the
Ctrl+Num
2. Press F11 to call the
3. Select the System entry and press
Basic configuration of the KVM-over-IP™ connection
Matrix systems > [Name] > Console modules
.
IP-CPU
IP-CON ).
IP-CON
No multicast video
(default) hotkey to open the on-screen display.
Configuration menu.
Enter .
or on
) send the video streams via multi-
IP-CPU ) send the video
).
)!
G&D ControlCenter-IP-XS · 17