RADEMACHER RP-S1-650N-1 Einbau- Und Bedienungsanleitung Seite 51

Alarm setting
If the alarm is switched on, the door operator
beeps if the door is open for longer than 10
minutes. The door operator beeps for 30
seconds every 10 minutes.
1. Press „+" (press several
times if necessary) until
„6" is displayed
4. Press „P" in order to
store the alarm setting
Automatic closing time setting
NOTE
Before the door closes automatically, the door operator
beeps for 20 seconds. At the same time the light flashes.
1. Press „+" (press several
times if necessary) until
„7" is displayed
2. Press „P",
the display is „0"
(0 = off = factory setting)
5. Conclude programming
(refer to page 53, method 2)
or
proceed with next setting.
2. Press „P",
the display is „0"
(0 = off = factory setting)
To end the beeping:
Press the door control button to fully close the door.
3. Press „+",
the display is „1"
(1 = on = the alarm setting is
switched on)
When the door starts closing, the light shines durably and it
beeps permanently.
After the door has closed, the door operator ends the
beeping and the light remains on for a further 3 minutes.
3. Press „+",
the display is „1"
(1 = on = automatic closing
time = 30 seconds)
GB
51