RADEMACHER RP-S1-650N-1 Einbau- Und Bedienungsanleitung Seite 45

(C) Installation of the door bracket (8)
3. Screw the door bracket (8) tight with the
enclosed self-tapping hexagon screws
(8 x 15 mm).
4.
Finally, fix the door connector (12) to the
door bracket (8) with the enclosed bolt
(9).
NOTE
A straight door connector is supplied pre-assembled, and
this is permanently fixed to the rail.
If you wish to use the bent door connector (12)
enclosed (depending upon your door particular
configuration), you must attach this with two hexagon
screws (8 x 20) to the straight door connector.
5.
Finally, secure the bolt (9) by attaching
the securing bolt (11) to prevent it from
slipping out.
(B) Installation of the middle support clip (13)
1. Fit the middle support (13) clip at a
suitable place, as near as possible to the
middle point between the door and the
door operator head.
Key
13 = Middle support clip
14 = Hexagon screws (8 x 60 mm)
13
14
GB
9
45