Appendix B: Configuring The Pc - MSI RG54SE II Handbuch

Appendix B: Configuring the PC

In this section, we'll introduce how to install and configure the TCP/IP correctly in
Windows 95/98. First make sure your Ethernet Adapter is working, refer to the adapter's
manual if needed.
1. Install TCP/IP component (If you use Windows 2000 or later, you can skip this
step.)
1) On the Windows taskbar, click the Start button, point to Settings, and then click
Control Panel.
2) Double-click the Network icon, click on the Configuration tab in the appearing
Network window.
3) Click on the Add button. Select Protocol, and then click Add.
4) Under Manufacturers on Select Network Protocol page, highlight Microsoft.
Under Network Protocols, highlight TCP/IP. Click OK. TCP/IP protocol will
take effect after reboot.
2. Configure TCP/IP for your computer
1) On the Windows taskbar, click the Start button, point to Settings, and then click
Control Panel.
2) Double-click the Network icon, highlight the bound TCP/IP tab in the appearing
RG54SE II 54M Wireless Router User Guide
Figure B-1 Add Network Protocol
Figure B-2 Select Network Protocol
- 60 -