Herunterladen Inhalt Inhalt Diese Seite drucken

Chapter 3: Connecting The Router; System Requirements; Installation Environment Requirements; Connecting The Router - MSI RG54SE II Handbuch

54mbps wireless router
Vorschau ausblenden Andere Handbücher für RG54SE II:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Chapter 3: Connecting the Router

3.1 System Requirements

Broadband Internet Access Service (DSL modem/Cable modem/Ethernet)
One DSL/Cable modem that has an RJ45 connector (you do not need it if you
connect the router to the Ethernet)
Each PC in the LAN needs a working Ethernet Adapter and an Ethernet cable with
RJ45 connectors
TCP/IP protocol must be installed on each PC
Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator
6.0 or later

3.2 Installation Environment Requirements

Do not place in direct sunlight or near a heater or heating vent
Do not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space
on all sides of the router
Well ventilated (especially if it is in a closet)
Operating temperature: 0 ~40
Operating Humidity: 10%~90%RH, Non-condensing

3.3 Connecting the Router

Before you install the router, you should connect your PC to the Internet through your
broadband service successfully. If there is any problem, please contact your ISP. After
that, please install the router according to the following steps. Don't forget to pull out the
power plug and keep your hands dry.
1.
Power off your PC, Cable/DSL modem, and the router.
2.
Locate an optimum location for the router. The best place is usually near the center
of the area in which your PC will wirelessly connect. The place must accord with the
Installation Environment
3.
Adjust the direction of the antenna. Normally, upright is a good direction.
4.
Connect the PCs and each Switch/Hub in your LAN to the LAN Ports on the router,
shown in figure 3-1. (If you have the wireless NIC and want to use wireless
connector, you can skip this step.)
5.
Connect the DSL/Cable Modem to the WAN port on the router, shown in figure 3-1.
6.
Connect the AC power adapter to the AC power socket on the router, and the other
end into an electrical outlet. The router will start to work automatically.
7.
Power on your PC and Cable/DSL modem.
RG54SE II
54M Wireless Router User Guide
(32 ~104 )
Requirements..
- 6 -

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis