Operation; Menu Structure - EuroLite CAT-80 Beam Effect Bedienungsanleitung

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller as well as
wireless via QuickDMX
Transmitter/Receiver.
After you connected the effect to the mains, the LED CAT-80 Beam Effect starts running. During the Reset,
the motors are trimmed and the device is ready for use afterwards.
The main menu is accessed by pressing the MENU button. Browse through the menu by pressing the MENU
button. Press the ENTER button in order to select the desired menu. You can change the selection by
pressing UP or DOWN. Confirm every selection by pressing the ENTER button. The functions provided are
described in the following sections.

Menu structure

Main menu
Set Address
Mode Choice
Sensitive
Reset
The display shuts off after a few seconds of inactivity.
with the optionally
Sub menu
001 – 506 Setting the DMX starting address
Auto
Automatic show program
DMX
DMX mode
Sound
Sound controlled show program
Manu
000 – 255 Dimmer Total brightness 0-100%
000 – 009 No function
010 – 255 Strobe Effect slow > fast
Gobos
000 – 009 Open
010 – 019 Gobo1
Gobo2
020 – 029
030 – 039 Gobo3
040 – 049 Gobo4
050 – 059
Gobo5
060 – 069 Gobo6
070 – 079 Gobo7
Gobo8
080 – 089
090 – 098
Gobo9
099 – 255
Rainbow effect fast > slow
Flower Rotation slow > fast
000 – 255
Mirror Cylinder Rotation slow > fast
000 – 255
Horizontal Cylinder Movement, gradual adjustment of the
000 – 255
mirror cylinder position from left to right
000 – 100 Microphone sensitivity with increasing sensitivity
Motor reset
available EUROLITE
Function
23/28
QuickDMX USB Wireless
00143444.DOCX, Version 1.0