Wireless DMX transmission with QuickDMX
The device features an alternative DMX input for a QuickDMX receiver (sold separately). CRMX and WDMX
receivers are compatible and can also be used. The connector allows a DMX control signal to be transmitted
wirelessly to the device, eliminating the need for complex wiring to the DMX controller. The connector is
designed as a USB port which provides the required 5 V operating voltage for the receiver.
Occupation of the USB port:
Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1
Connect the device via the enclosed mains cable to a grounded mains socket. Thus the unit is switched
on.
2
To switch off the unit, disconnect the power plug.
3
Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a
mains outlet which is switchable.
22/28
00143444.DOCX, Version 1.0