Herunterladen Inhalt Inhalt Diese Seite drucken

Master/Slave Operation; Dmx Operation - EuroLite CAT-80 Beam Effect Bedienungsanleitung

Led-strahleneffekt mit 80-w-cob-led in kaltweiß und goborad
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Master/slave operation

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
Configure all slave units before connecting the master unit. For this, set each slave device to the DMX
address 001 and confirm with ENTER.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3
Select the desired show mode (Sound or Auto) at the master unit. The interconnected devices will now
operate synchronously.

DMX operation

To be able to operate the device in DMX mode, it must first be set to DMX under the Mode Choice menu
item (see Menu structure).
Setting the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 7 control channels. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1
Press the UP or DOWN button so many times until DMX Address is indicated on the display. Confirm
with the ENTER button.
2
Now the display calls up the menu item for the DMX starting address: 001.
3
Use the buttons UP and DOWN to set the address. Confirm with the ENTER button.
4
The display will not flash if DMX signals are being received.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed to the
same address, they will work synchronously.
Overview for gobo wheel:
6
Magenta
7
Green
8
Pink/
Light blue
9
Dark blue
5
Orange
4
1
Red
open
3
Yellow
2
Light blue
24/28
00143444.DOCX, Version 1.0

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

51918595

Inhaltsverzeichnis