Silvercrest SVEB 160 B2 Bedienungsanleitung Seite 62

3) Lay the open end of the bag as far into the appliance so that the opening
of the bag is located centrally under the lower seal ring 3. The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7. If the bag is lying over one or both limits 6/7, it cannot be
sealed correctly:
NOTE
► The bag opening must lie fl at on the sealing wires 4. Otherwise the sealing
does not work properly.
4) Close the appliance lid 1. The press seal e presses the bag onto the
sealing wires 4, to create a smooth seam. Ensure that both corners of the
appliance lid 1 click into place. If necessary, press them down once again
on the markings
and locks shut.
5) Press the
sealing process is completed, the control lamps t/a switch off .
NOTE
► You can stop the vacuum sealing process at any time by pressing the
button a. The control lamps t/a will then switch off . Press the
t again to resume the sealing process.
SVEB 160 B2
and so that the appliance lid 1 clicks into place
button t. The control lamps t/a light up. As soon as the
button
GB │ MT │ 59 ■