Disposal - Kärcher RCV 5 Bedienungsanleitung

Fault
The cleaning robot does
not clean efficiently or
leaves dust behind
The cleaning robot does
not continue cleaning
The cleaning robot does
not start
The cleaning robot can-
not connect to
the WLAN/The cleaning
robot goes offline

Disposal

WARNING
Cause
The dust container is full.
The filter is clogged.
A foreign object has become caught in
the brush
The cleaning robot is in "Do not disturb"
mode.
The cleaning robot is being charged
manually or has been placed in the
charging station.
Ambient temperature is below 0 °C or
above 35 °C.
Charging state is too low.
Laser distance sensor (LiDAR) is
blocked.
Collision sensor is dirty or too close to the
virtual wall.
Fall sensors are dirty.
The water reservoir or dust container is
not installed or incorrectly installed.
Filter not installed or incorrectly installed. 1. Make sure that the filter is correctly in-
Filters dirty.
Wiper cloth or wiper cloth holder not or in-
correctly installed.
The cleaning robot is jammed or stuck.
The cleaning robot or one of its wheels
has no floor contact.
The cleaning robot is not connected to
the network or is not within the range of
the WLAN signal.
The WLAN signal is too weak.
Rectification
1. Empty the dust container, see chapter
Emptying the dust container.
1. Clean the filter, see chapter Cleaning the
filter
1. Clean the brush, see chapter Cleaning the
brush.
2. Clean the side brush, see chapter Cleaning
the side brush.
1. Ensure that the cleaning robot is not in "Do
not disturb" mode.
1. Wait until the cleaning robot is fully
charged.
1. Use the cleaning robot at temperatures
above 0 °C and below 35 °C.
1. Charge the cleaning robot.
1. Clean the laser distance sensor with a dry
cloth.
2. Remove obstacles blocking the laser dis-
tance sensor.
3. Move the cleaning robot to another location
and start it.
1. Remove foreign objects by carefully tap-
ping on the collision sensor.
2. Move the cleaning robot to another location
and start it.
1. Clean the fall sensors with a dry cloth.
1. Ensure the water reservoir or the dust con-
tainer is installed and correctly latched into
place, see chapter Installing the water res-
ervoir or. Installing the dust container
stalled.
1. Clean the filter, see chapter Cleaning the
filter.
2. If the error persists, replace the filter, see
chapter Replacing the filter.
1. Ensure that the wiper cloth and wiper cloth
holder are correctly installed, see chapter
Installing the wiper cloth or Installing the
wiper cloth holder.
1. Remove obstacles.
1. Place the cleaning robot on a flat surface.
1. Make sure that the cleaning robot is con-
nected to the network and is within the
range of the WLAN signal.
2. Make sure that the WLAN password is cor-
rect.
3. Reset the WLAN and connect again (5
GHz WLAN networks are not supported).
1. Make sure that the cleaning robot is within
range of the WLAN signal.
This device contains Lithium-Ion rechargea-
ble batteries. The removal and proper dis-
posal of lithium-ion batteries must be
carried out in accordance with national and
state regulations.
English 23