Installation; Unpacking And Positioning - Pkm KSGS351 IX Bedienungsanleitung

3. Installation

All dimensions in these chapters are given in millimetres.
The minimum distances required for proper ventilation can be found in chapter 3.2.2
V .
ENTILATION

3.1 Unpacking and positioning

WARNING! While unpacking, the packaging materials (polythene bags,
polystyrene pieces, etc.) should be kept away from children and pets.
CHOKING HAZARD! RISK OF INJURY!
1. This appliance is not intended for built-in installation.
2. Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
3. Remove all packaging materials.
4. The accessories of your appliance can be protected from damage due to
transportation (adhesive tapes etc.). Remove such tapes very carefully. Remove
remains of such tapes with a damp cloth using lukewarm water and a mild detergent
(see also chapter
of the back of the appliance!
5. Install the appliance in a suitable position with an adequate distance from sources of
heat and cold.
6. If installation near a heat source is unavoidable, use a suitable insulation plate or
keep the following minimum distances to the heat source:
To another refrigerators:
To electric cookers:
To radiators or ovens:
7. Install the appliance in a dry and well-ventilated place.
8. Protect the appliance from direct sunlight.
9. The door(s) must open completely and without hindrance.
10. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
11. Check that the appliance and the power cord are not damaged.
12. Connect the appliance to the mains properly.
13. The rating plate is inside the appliance or at the back.
CLEANING AND MAINTENANCE
~ 80 ~
). Never remove any components
min. 20 mm
min. 30 mm
min. 300 mm