Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
– Veneers or plastic coverings on the built-
in furniture require heat-resistant adhesive
(100 °C). If the adhesive and surfaces are
not heat-resistant, the covering may warp
and come loose.
– An intermediate shelf is required if a draw-
er is to be installed below the oven.
– The installation recess may not have a rear
panel, at the most it may have an add-on
edge measuring no more than 50 mm.
– The built-in cabinet can be equipped with
either ledges/rails or an intermediate shelf
with ventilation cut-out.
Installation under a worktop
➍
➌
➎
➋
➏
➊
Installation
– The installation recess must have the fol-
lowing minimum dimensions
– Installation under a worktop
❶
600 mm
➋
560 +8 mm
❸
min. 560 mm
➍
min. 580 mm
❺
max. 50 mm
❻
max. 50 mm
– Installation in an upright cabinet
❶
595 mm
➋
560 +8 mm
➌
min. 550 mm
➍
min. 585 mm (➌ + ➎)
➎
min. 35 mm
Installation in an upright cabinet
➍
➌
➋
Page EN-25
➎
➊
Werbung
Inhaltsverzeichnis
