Stand-Alone Mode - EuroLite LED Mega Strobe 768 Bar Bedienungsanleitung

Stand-alone mode

DMX Monitor
Here you can read out the DMX values for each DMX channel.
1 Press the MENU button so many times until DMX Monitor is indicated on the display. Confirm with the
ENTER button.
2 Use the buttons UP and DOWN to select the desired DMX channel mode and confirm with the ENTER
button.
3 You can now read out the desired DMX value for each channel in the selected DMX mode. Confirm with
the ENTER button.
Automatic mode
In automatic mode, 37 various show programs are available that run at an adjustable speed. Additionally, a
desired color can be set.
1 Press the MENU button so many times until Auto is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN (Auto 00 – Auto 36) to select the desired show program.
Confirm with the ENTER button.
2 The display now indicates Speed. Confirm with the ENTER button. Use the buttons UP and DOWN to
adjust the running speed of the program from 000 (slow) to 255 (fast). Confirm with the ENTER button.
With the MENU button you can return to the main menu.
Effect on Auto
In this mode, you can set the desired brightness and strobe speed of the programs in Automatic Mode.
1 Press the MENU button so many times until Effect on Auto is indicated in the display. Confirm with the
ENTER button.
2 The display shows Dimmer. Confirm with the ENTER button
3 Use the buttons UP and DOWN to select the desired brightness, from 000 (dark) to 255 (bright).
Confirm with the ENTER button.
4 The display now indicates Strobe. Confirm with the ENTER button.
5 Use the buttons UP and DOWN to adjust the strobe speed from 000 (slow) to 255 (fast). Confirm with
the ENTER button.
With the MENU button you can return to the main menu.
Mas Mode
In this mode, you can set the Master and Slave devices.
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
Configure all slave units before connecting the master unit.
1 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
2 Press the MENU button so many times until Mas Mode is indicated in the display. Confirm with the
ENTER button.
3 Use the buttons UP and DOWN to select the desired setting, yes or no for Master or Slave, depending
upon the device. Confirm with the ENTER button.
4 Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.
With the MENU button you can return to the main menu.
32/44 00140513, Version 1.0