Herunterladen Inhalt Inhalt Diese Seite drucken

Care And Service; Optional Accessories; Troubleshooting Guide; Technical Data - Kärcher WD 2-18 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Note
The suction hose can be wrapped around the device
head and attached to the device head with the help of
the hose collar.
6. Store the device in a dry and frost-proof room.
Removing the battery pack
Note
During longer work breaks, remove the battery pack
from the device and secure it against unauthorised use.
● Push the battery pack upwards and remove it from
the device.
Illustration P
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transportation.
Manual transport
1. Lift and carry the device by the carrying handle.
Transport in vehicles
1. Secure the device against slipping and tipping over.

Care and service

General care instructions
 Clean the device and plastic accessory parts with a
commonly available plastic cleaner.
 Rinse the container and accessories with water, as
necessary, and dry them before further use.
Clean the foam filter / cartridge filter
1. If necessary, the foam filter / cartridge filter can be
cleaned under running water. To do this, remove the
foam filter from the filter basket. The cartridge filter
can be unlocked and removed by turning it towards
the symbol
.
2. Do not rub or scrub the foam filter / cartridge filter
when cleaning it.
3. Allow the foam filter / cartridge filter to dry complete-
ly before using it again.
4. Depending on the filter type, reinsert as follows:
 Foam filter: Pull the filter over the filter basket and
ensure that it is fixed correctly.
 Cartridge filter: Install the filter on the filter basket,
turn it towards the symbol
is fixed correctly.
Illustration R
Illustration S

Optional accessories

Note
For variants with a foam filter, a cartridge filter can be
purchased later as a special accessory and used in-
stead of the foam filter.
1. Before inserting the cartridge filter, remove the black
cover cap and keep it with the foam filter for later
use.
2. Put on the cartridge filter and screw it tight.
Illustration R

Troubleshooting guide

Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
12
Device not running
Battery pack not correctly seated in the battery pack
mounting.
1. Push the battery pack into the battery pack mount-
Note
If necessary, remove the battery pack again and reinsert
it until it latches into place.
Charging state of the battery pack (see display) too low.
1. Charge the battery pack.
Defective battery pack or charger.
1. Replace the battery pack or charger.
Device switches off automatically
Device/battery pack overheated.
 Wait until the device/battery pack has cooled down.
Declining suction performance
Accessories, the suction hose or the suction tubes are
clogged.
 Remove the clog with a suitable aid.
The filter bag is full.
 Replace the filter bag.
The foam filter / cartridge filter is dirty.
 Clean the foam filter / cartridge filter (see chapter
The foam filter / cartridge filter is damaged.
 Replace the foam filter / cartridge filter.
Electrical connection
Degree of protection
Protection class
Battery voltage
Nominal power
Filling quantity
Tank content
Device performance data
Operating time when bat-
tery is fully charged in nor-
mal operation
Subject to technical modifications.
and ensure that it
Français
ing until it latches into place.
Clean the foam filter / cartridge filter).

Technical data

Contenu
Remarques générales.........................................
Consignes de sécurité.........................................
Utilisation conforme.............................................
Protection de l'environnement.............................
Etendue de livraison............................................
Garantie ..............................................................
Description de l'appareil ......................................
Charger la batterie ..............................................
Montage des roues directionnelles .....................
Mise en service ...................................................
Utilisation.............................................................
Transport .............................................................
Entretien et maintenance ....................................
** Accessoires spéciaux ......................................
Dépannage en cas de défaut ..............................
Caractéristiques techniques................................
WD 2-18 WD 3-18
IPX4
IPX4
III
III
V
18
18
W
245
245
l
12
17
min
10
18
13
13
13
14
14
14
14
14
14
14
14
15
16
16
16
16
16

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Wd 3-18Wd 3-18 s

Inhaltsverzeichnis