Teka TZC32320 Montageanleitung Und Empfehlungen Zur Verendung Und Wartung Seite 32

EN
fig. 1
INSTALLATION AND SETUP SHOULD BE CARRIED
OUT BY AN AUTHORISED TECHNICIAN IN LINE WITH
CURRENT INSTALLATION STANDARDS.
Positioning the hob
To install these models, an opening with the dimensions
The worktop fastening system is suitable for units 20, 30
and 40 mm thick.
The minimum distance between the surface supporting
the cooking pans and the lower part of the kitchen unit or
the hood located above the hob should be 650 mm. If the
hood's installation instructions recommend that the gap is
distances
greater than this, you should follow this advice.
The unit where the hob and oven will be located will be
CABINET
In mixed induction - vitroceramic hobs, if you would like
to have a cabinet or a cutlery drawer under the hob, it is
necessary to put a separation board in between the two.
The board should be situated 20 mm below the underside
of the hob, leaving a free space of at least 20 mm until the
This prevents accidental contact with the hot surface of
the casing of the heating elements under the apparatus
-
er.
The oven should be installed according to the correspond-
ing manual.
An opening of 20 mm should be made in the back part of
32