Teka TZC32320 Montageanleitung Und Empfehlungen Zur Verendung Und Wartung Seite 38

EN
products containing sugar
it.
To keep the appliance in good
condition, clean it using suitable
products and implements once
it has cooled down. This will
make the job easier and avoid
the build-up of dirt Never use
harsh cleaning products or
tools that could scratch the
surface, or steam-operated
equipment.
Light dirt not stuck to the
surface can be cleaned using
a damp cloth and a gentle
d e t e r g e n t o r w a r m s o a p y
water. However, for deeper
stains or grease use a special
cleaner for ceramic hot plates
and follow the instructions on
the bottle. Dirt that is firmly
stuck due to being burned
repeatedly can be removed
using a scraper with a blade.
Slight tinges of colour are
c a u s e d b y p o t s a n d p a n s
w i t h d r y g r e a s e r e s i d u e
underneath or due to grease
between the glass and the
pot during cooking. These can
be removed using a nickel
scourer with water or a special
cleaner for ceramic hot plates.
Plastic objects, sugar or food
containing a lot of sugar that
have melted onto the surface
must be removed immediately
using a scraper.
Metallic sheens are caused
by dragging metal pots and
pans over the glass. They
can be removed by cleaning
thoroughly using a special
cleaner for ceramic glass hot
plates, although you may need
to repeat the cleaning process
several times.
38
T E K A I N D U S T R I A L S . A .
reserves the right to make
changes to its manuals that
it deems necessary or useful,
without affecting the product's
essential features.
considerations
product or its packaging
that this product is disposed
Before calling the technical
s e r v i c e ,
verifications specified below.
Ensure that the power cable is
plugged in.
If there is molten material
between the pot and the glass,
set the hot plate to maximum
power and try to separate
them.
If any of the sensors is active
more than 10 seconds, this
error situation occurs and error
code"F1" is showed. This error
o n t h e
can be related with different
roots. One of them is that there
may be an object (fork, knife...)
on the any of the sensor.
Make sure that there is no any
object on the control unit, hob
glass is wiped with a dry cloth.
If error situation continue after
this solution, please take out
plug or switch off fuse switch
for 10 second.
If more than 2 sensors are
sensed at same time, this
error situation occurs and error
code"F2" is displayed.
• T h e r e
o b j e c t ( p o t ... ) o r w a t e r
accumulation(overflow liquid
from pot...) that cover more
p e r f o r m t h e
m a y b e a n