Teka TZC32320 Montageanleitung Und Empfehlungen Zur Verendung Und Wartung Seite 37

COOK START FUNCTION OFF
After at least 10 seconds have elapsed
since the beginning of the automatic
cook start function:
The hot plate must be selected.
Press touch key
indicator reaches level 9 and the
automatic cook start function will
be deactivated.
This function makes it easier to cook,
as you do not need to be present
throughout the process: the timed hot
after the set time has lapsed. There
is a separate timer for each hot plate,
which allows all of the hot plates to be
timed simultaneously.
With these models you can use the
clock as a timer for the hotplates for
times ranging from 1 to 99 minutes. All
the cooking areas can be programmed
individually and in a simultaneous
manner.
TIMING ONE HOTPLATE
The cooking zone to be timed must
be selected.
Select a power level for the hotplate
from 1 to 9 using the touch keys
or (5/4).
Press clock touch key
Timer indicator (12) will display 00.
Depending on the model, the timed
cooking surface indicator (13) will
On the power indicator (3),
during the time set.
4 Immediately afterwards, enter a
cooking time between 1 and 99
minutes, by using the touch keys or
(5/4).
When the power indicator (3) stops
time automatically. The respective
timed hotplate disolay (11) will
Or, when the countdown starts, the
relevant power level and
alternately on the power indicator (3)
of the relevant heater area.
When the clock reaches 01, it will
switch from counting down minutes
(5) till the
to seconds.
Once the selected cooking time has
elapsed, the heating zone being timed
series of beeps for several seconds.
The timer indicator will display a
has been disconnected.
If you wish to time another hotplate at
the same time, repeat steps 3 and 4.
indicator displays an H or otherwise an
any sensor.
CHANGING THE PROGRAMMED
TIME
To change the progrmmed time, you
must press the touch key of the timed
hotplate (2) to select it and then the
clock (10). You may then read and
change the time.
DISCONNECTION OF THE TIMER
If you want to stop the timer before the
programmed time is up
First select the hotplate and then
press clock touch key
(10).
Use the touch key
recude the time to 00. The clock is
cancelled.
Alternative metod :
After zone selection if timer touch key
is pressed for two seconds, the related
timer will be cancelled.
If due to an error one or several hot
will be automatically disconnected
after a set amount of time (see table 2).
Table 2
Selected
power
level
1
2
3
4
5
6
7
8
9
has been triggered, a 0 is displayed if
the glass surface temperature is not
dangerous for the user or an H if there
is a burn risk.
To reconnect the appliance, switch it
then switch it on again.
(10).
* Use pots or pans with thick,
(4) to
* Pans with a smaller diameter than
the shown heating area are not
recommended.
* Do not slide pots and pans over the
glass as they may scratch it.
* Although the glass can withstand
knocks from large pots and pans
without sharp edges, try not to
knock it.
* To prevent damage to the ceramic
glass induction surface, try not
to slide the pots and pans over
the glass, and keep the bottoms
of the vessels clean and in good
condition.
EN
MAXIMUM OPERATION
TIME
(in hours)
10
5
5
4
3
2
2
2
1
(1) and
hobs
37