Profibus/Twin Profibus Signal Description; General; Power Source Modes -Ts/Tps, Mw/Tt Range; Power Source Modes - Tst Range - Fronius Profibus Bedienungsanleitung

Profibus/Twin Profibus signal description

General

The following signal descriptions apply to an interface with a KL 6021-0010 com-
munication terminal (standard version)
Extra terminals can also be installed in a robot interface. However, the number
that can be installed is limited by the size of the housing.
IMPORTANT! When installing extra terminals, the process data image changes.
Power source Depending on the selected mode, the Profibus/Twin Profibus interface can trans-
modes -TS/TPS, fer numerous kinds of input and output signals.
MW/TT range
Mode
MIG/MAG standard synergic welding
MIG/MAG pulse synergic welding
Job mode
Parameter selection internal
TIG welding
CC/CV
Standard manual welding
CMT/special process
Power source Depending on the selected mode, the Profibus/Twin Profibus interface can trans-
modes - TSt ran- fer a wide variety of input and output signals.
ge
Mode
MIG/MAG standard welding
Flag mode
Parameter selection internal
MIG/MAG standard manual welding
E05 E04
0 0
0 0
0 1
0 1
1 1
1 0
1 0
1 1
E13 E12
0 0
0 1
0 1
1 0
E03
0
1
0
1
0
1
0
1
E11
0
0
1
0
61