Inhaltsverzeichnis
Werbung
DK
44
•
Empty the dust bag regularly in order to
obtain an efficient dust extraction.
The adapter of the dust bag can also be used to
connect a vacuum cleaner to the machine.
Grip
The use of the belt sander is made easier
because of the two grips one on the front side
and one on the back. Through that you can hold
the machine with two hands, you have a better
control of the machine and there is less risk to
becoming in touch with the moving parts. Hold
the belt sander always with both hands.
Operating instructions
Make sure that the machine has reached its full
speed before placing the machine on the work
piece. This will prevent an overload of the
machine.
For sanding wood, place the machine
approximately 15° out of the grains of the wood.
Move the belt sander continuous over the work
piece.
•
Do not bend the sanding belts
•
Do no use the same sanding belt for sanding
wood and metal
•
Do not bring too much pressure to your
machine, this will only delay the sanding.
4. SERVICE AND MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate over
a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Malfunction
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
1. The electromotor gets hot
•
The cool ventilation slots in the motor are
stopped up with dirt.
•
Clean the cool ventilation slots.
Ferm
Ferm
•
The motor is defect.
•
Please contact the service address on the
warranty card.
2. The connected machine does not work
•
Interruption in the mains connection.
•
Check mains connection for fracture.
•
Please contact the service address on the
warranty card.
3. The dust is not absorbed
•
This can be caused by a stopped up dust
extraction
•
Clean your dust collection opening
Repairs and servicing should only be
carried out by a qualified technician or
service firm.
Cleaning
Regularly clean the device's casing with a soft
cloth, preferably after each use. Keep the fan
slits free of dust and dirt. Remove stubborn dirt
using a soft cloth, dampened with soapy water.
Do not use solvents such as benzene, alcohol,
ammonia, etc, which might damage the plastic
parts.
Lubrication
The device does not need any additional
lubrication.
Defects
If a defect appears due to a part wearing out,
please contact the service center on the warranty
card. At the end of these instructions there is an
exhaustive overview of the parts that can be
ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Damaged and/or disposed of electrical
or electronic devices must be dropped
off at recycling stations intended for that
purpose.
Warranty
Read the warranty conditions on the separately
supplied warranty card.
GB
05
Werbung
Inhaltsverzeichnis
