Inhaltsverzeichnis
Werbung
GB
Immediately switch off the machine when:
•
Excessive sparking of the carbon brushes and
verticiliosis in the collector.
•
Interruption of the mains plug, mains lead or
mains lead damage.
•
Defect switch
•
Smoke or stench of scorched isolation
Electrical safety
When using electric machines always observe
the safety regulations applicable in your country
to reduce the risk of fire, electric shock and
personal injury. Read the following safety
instructions and also the enclosed safety
instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class ll machine. Your machine is
double insulated; therefore no earthwire
is required.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
2
. When using a cable
reel always unwind the reel completely.
3. OPERATION
Always observe the safety instructions
and applicable regulations.
Choice of the sand-paper
Coarse sand-paper (grain 50) removes in general
the bigger part of the material and fine sand-
paper is used for the finishing. If the surface is
not even, then start with rough sand-paper.
Further you use middle coarse sand-paper(grain
80) to remove the scratches left behind by the
coarse sand-paper and finally you take fine sand-
paper (grain 120) for the finishing.
04
Removing and Installing the sanding belt
Fig. C1 + C2
Before assembly the sanding belt
always remove the plug from the mains.
•
Put the machine on its side, with the drive belt
cover down wards.
•
Loosen the sanding belt fastener (4).
•
Remove the sanding belt from the machine
•
Put a new sanding belt on the machine, make
sure that the direction arrows on the sanding
belt are pointing in the same direction as the
direction indicator (5).
•
Fasten the sanding belt fastener again (4).
Aligning the sanding belt
Fig. B
If the sanding belt doesn't run parallel with the
outer edge of the housing, the sanding belt must
be aligned. Move the sanding belt in the correct
position with the adjusting knob (12). By turning
the adjusting knob clockwise the sanding belt will
move to the inside and by turning anti-clockwise
the sanding belt will move to the outside.
Switching on and off
Fig. B
•
To switch the machine on press the on/off
switch (7).
•
To switch the machine off release the on/off
switch.
If continuous operation is required the
blocking switch (8) must be used:
•
Switch the machine on to press the on/off
switch.
•
Press the blocking switch and release the
on/off switch.
•
To switch the machine off press the on/off
switch again and release the on/off switch.
Mounting dustbag
Fig. B
A complete dust bag is enclosed. Put the wire-
bracket (inside the dust bag) into to the adapter
of the dust bag (when not mounted). The end of
the bracket has to point upwards. Use the dust
bag to collect dust which is released during
sanding.
•
Put the dust bag on the dust collection
opening
Ferm
Ferm
DK
45
Werbung
Inhaltsverzeichnis
