Possible Cause - Ryobi RM480e Bedienungsanleitung

TROUBLESHOOTING
If these solutions do not solve the problem, contact an authorised service centre.
Problem

Possible cause

The battery charge is low.
The charger is connected to the product.
The product does not
start. The start key is not installed or is in the
OFF position.
Poor battery cable connections
The start key is not installed or is in the
OFF position.
The parking brake is engaged.
The product does not
move.
The brake pedal is pressed and/or
accelerator pedal is not pressed.
The charger is connected to the product.
The tyre air pressure is uneven.
The mower deck is not level.
The product is cutting
The blade is worn, bent, loose, or dull.
grass unevenly.
There is build-up of debris under the
product.
The mowing speed is too fast.
There are wet grass clippings sticking to the
underside of the deck.
The grass is too high.
The product is not
mulching properly.
The blade is worn, bent, loose, or dull.
The mowing speed is too fast.
The blade is unbalanced, loose, or
excessively or unevenly worn.
The product is
vibrating at a higher
The motor shaft is bent.
speed.
The side discharge chute or opening is
plugged.
The grass is wet.
Poor grass discharge.
The mowing speed is too fast.
The grass is too high.
Solution
Charge the battery.
Disconnect the charger from product.
Insert the start key, and turn it to the ON position.
Check and clean all the battery connections.
Insert the start key, and turn it to the ON position.
Disengage the parking brake.
Release the brake pedal, and step on the accelerator pedal.
Disconnect the charger from product.
Check the air pressure in all four tyres.
Perform cutting deck level adjustment.
Replace the blade.
Clean the underside of the mower deck.
Mow at a slower speed.
Wait until the grass dries before mowing.
Mow once at a high cutting height, then mow again at the preferred
height.
Replace the blade.
Mow at a slower speed.
Replace the blade.
Stop the motor, and remove the start key. Inspect the product for
damage. Have the product serviced by an authorised service centre
before restarting.
Clean the side discharge chute and opening.
Allow grass to dry before mowing.
Mow at a slower speed.
Mow once at a high cutting height, then mow again at the desired
height.
13
Original Instructions
EN
FR
DE
DA
SV
FI
NO