Symbols In This Manual; Unpacking - Ryobi RM480e Bedienungsanleitung

Do not dispose of waste batteries,
waste electrical and electronic
equipment as unsorted municipal
waste. Waste batteries and waste
electrical and electronic equipment
must be collected separately. Waste
batteries, waste accumulators, and
light sources have to be removed
from the equipment. Check with
your local authority or retailer for
recycling advice and collection
point. According to local regulations,
retailers may have an obligation
to take back waste batteries and
waste electrical and electronic
equipment free of charge. Your
contribution to the reuse and
recycling of waste batteries and
waste electrical and electronic
equipment helps to reduce the
demand of raw materials. Waste
batteries, in particular containing
lithium, and waste electrical and
electronic equipment contain
valuable and recyclable materials,
which can adversely impact the
environment and the human
health if not disposed of in an
environmentally compatible manner.
Delete personal data from waste
equipment, if any.

SYMBOLS IN THIS MANUAL

Parts or accessories sold
separately
Note
Warning

UNPACKING

See page 96-97.
■ Remove and set aside all accessible packaging
and wrap from the unit and parts. Do not discard the
packing material until you have carefully inspected and
satisfactorily operated the product.
■ Inspect the product carefully to ensure that no breakage
or damage occurred during shipping.
■ If any parts are damaged or missing, contact an authorised
service centre. Do not assemble the product until the
parts are replaced with new original manufacturer's
parts. Assembling the product with damaged, missing,
or incorrect parts could result in serious personal injury.
■ If any parts are already assembled to the product when
you unpack it, verify that the part is assembled correctly,
is properly tightened, and is torqued correctly (where
applicable) before proceeding to the next assembly step.
The use of a product that may have been improperly
assembled could result in serious personal injury.
ASSEMBLY
See page 100-102.
■ The product should be assembled while positioned on
the bottom frame. When assembly is complete, set the
cutting deck to its maximum height, then position a ramp
next to the frame bottom, and slowly and carefully drive
the product off the frame.
■ Strictly adhere to all
specifications. Failure to do so could cause serious
personal injury.
■ To prevent accidental starting that could cause serious
personal injury, always remove the start key from the
product when assembling the parts.
■ Use care when driving the product off of the frame, and
step on the brake pedal as needed to control the speed.
The product freely rolls if it is moved on an inclined
surface without stepping on the brake pedal or engaging
the parking brake. Failure to follow these instructions
can result in loss of control and result in death, serious
personal injury, or property damage.
■ If no ramp is available, slowly and carefully drive the
product off the frame in reverse while looking down and
behind. Driving the product off the frame in the forward
direction without a ramp can cause damage to the
cutting deck.
torque wrench tightening
11
Original Instructions
EN
FR
DE
DA
SV
FI
NO