Troubleshooting; Possible Cause - Eufab 16257 Bedienungsanleitung

6.8 TROUBLESHOOTING

Error/Fault

Possible cause

The connector of the monitor cable has
not been inserted into the 12 V vehicle
socket.
The fuse of the monitor cable connector
has been triggered and must be
replaced.
No function
The fuse of the 12 V vehicle socket has
been triggered and must be replaced.
The battery is empty
(only when used without charging
cable)
The memory card has not been inserted
correctly
Write protection of the memory card has
been activated
No saving
possible
The memory card is not formatted
There is not sufficient memory space
The memory card is defective
The lens of the camera is dirty
Strong light is acting directly on the lens
The monitor
of the camera
does not
show a clean
image
Incorrect light frequency set
Camera does
Camera misaligned, autofocus is
not show a
affected by other objects.
sharp image
14
Assistance/solution
Plug the connector of the charging cable into
the 12 V vehicle socket.
Plug the connector of the charging cable into
the 12 V vehicle socket.
Replace the fuse in the monitor cable
connector
Use the charging cable to connect the
camera to the 12 V vehicle socket.
Insert the memory card properly
Deactivate the write protection of the me-
mory card
Format the memory card (Format in section
6.5 Functions)
Delete some files in order to free up memory
space
Try using a different card
Carefully clean the lens
As soon as the strong light dissipates, the
image quality will be OK
Set the appropriate light frequency for
artificial light (Light frequency in section 6.5
Functions)
Align the camera so that the autofocus can
focus on the desired image section.