Memory Card; Installation; Connecting The Camera; Functions - Eufab 16257 Bedienungsanleitung

19 USB connector
19
Figure 3: Charging cable

6.2 MEMORY CARD

Inserting the memory card
Make sure that the dashboard camera has been
switched off. Insert the micro-SD into the slot
(Position 2 in the overview). Pay attention to ensure
that the memory card is correctly positioned. The
contacts of the memory card must face in the direction
of the lens. Carefully push the memory card into the
slot until it engages with a soft click.
Removing the memory card
Switch the camera off. To remove the memory card,
press down and release. The card will pop up and you
can remove it.
Removing the memory card with the
camera switched on may result in a loss of
data or damage to the device.

6.3 INSTALLATION

Clean the section of the windscreen where the camera
is to be mounted. Put the camera mount (Position 18
in the overview) into the mounting point (Position 6
in the overview) of the camera. Press the suction base
(Position 15 in the overview) against the windscreen.
Flip the lever (Position 16 in the overview). Undo the
coupling nut (Position 17 in the overview) on the ball
joint. Align the camera. Tighten the coupling nut up
again.

6.4 CONNECTING THE CAMERA

Plug the USB connector (Position 19 in the overview)
of the charging cable into the USB socket (Position 7
in the overview) of the camera. Lay out the charging
cable in such a way that it does not impede visibility
and does not hinder you during the journey. Plug the
vehicle connector (Position 20 in the overview) of the
charging cable into the 12 V socket of your vehicle.
20 Vehicle connector
20

6.5 FUNCTIONS

ON/OFF switch (Position 1 in the overview)
Long press:
Switches the camera on/off.
Video recording is started directly after the camera is
switched on.
Brief press:
Switches the Power-LED (Position 5 in the overview)
on/off.
OK button (Position 10 in the overview)
In Standby mode:
A brief press starts video recording (red dot flashes on
the display)
A second brief press stops video recording.
In Photo mode:
A brief press takes a photograph.
In Play mode:
A brief press plays the recorded video.
Menu button (Position 3 in the overview)
In Standby mode:
A brief press opens the menu for the video settings.
With the cursor buttons (Positions 11 and 13 in the
overview), you can select the various menu items.
Press the OK button to open the selected menu item.
Use the cursor buttons to select the setting in the
menu item, and confirm by pressing the OK button.
Settings in the video menu (symbol shows a
video camera in the top left of the display):
Resolution: FHD – HD - 720P 1280x720 - WVGA
848x480 - VGA 640x480
Loop recording:
Here, the camera records short video passages. When
the memory is full, the oldest recording will always be
deleted.
Switch off –1 minute –2 minutes –3 minutes –
5 minutes –10 minutes
Lighting compensation:
Here you can set the brightness of the video recording.
+2.0 ...+0.0 ... -2.0
Motion detector:
When the motion detector is activated, the
camera automatically starts recording when motion
is detected.
Switch off – switch on
11