Parking Mode Button (Position 12 In The Overview); Playing/Viewing The Recordings; Replacing The Fuse - Eufab 16257 Bedienungsanleitung

Language settings:
Set the menu language and confirm the selected
language using the OK button.
TV mode:
Set the television standard that matches your
television.
NTSC – PAL
Light frequency:
Set the frequency of the power network of your
country.
50 Hz – 60 Hz
Flash:
You can switch the Power-LED on permanently.
Switch off – switch on
Format:
The memory card is formatted, all data is lost.
Cancel – Confirm
Defoult setting:
The factory settings of the camera are restored.
Cancel – Confirm
Version:
Shows the version of the software on the camera.
Mode button (Position 14 in the overview)
Pressing the Mode button multiple times allows
you to switch the function modes in the following
sequence: Video mode – Photo mode – Play mode.
Parking mode button (Position 12 in the
overview)
Press the Parking mode button before switching the
camera off. The „P symbol" will be shown in the top
right of the display. After the camera is switched off,
it is in Parking mode, see also the „Gravity sensor" in
section 6.5 Functions.

6.6 PLAYING/VIEWING THE RECORDINGS

In order to view the recorded videos and photos, press
the Mode button to switch to Play mode. Use the
cursor buttons to select the desired video or photo.
Press the OK button to view the video or photo.
In order to view the recordings on your computer,
insert the memory card into an appropriate card
eader and connect to your computer.

6.7 REPLACING THE FUSE

Turn the tip of the 12 V connector of the charging cable
anti-clockwise until it is released from the connector
and it can be removed. The fuse is exposed and can be
removed from the connector. Replace the fuse with
another of the same strength and screw the tip back
into the connector.
Fuse: ø 6 x 30, 2 A, fast-blowing, 250 V
13