Product Safety Information - Ingersoll-Rand QA6 Serie Technische Produktdaten

Product Safety Information

Intended Use:
These Air Angle Wrenches and Nut Runners are designed for assembly applications requiring precise torque control, accuracy, consistency, and
repeatability.
Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious
•
injury.
Always turn o the air supply, bleed the air pressure and disconnect the air supply hose when not in use, before installing, removing
•
or adjusting any accessory on this tool, or before performing any maintenance on this tool or any accessory.
If the clutch is adjusted over the maximum power output of the tool, the clutch will not function and the tool will stall.
•
If the tool is operated below the recommended air pressure, the clutch at the higher torque settings may not function properly
•
causing the tool to stall.
If a tool stalls the full torque capacity of the tool will be applied to the operator's hands, unless a suspension arm or reaction bar is
•
used. This force may cause serious personal injury from crushing, pinching, loss of balance or loss of control of the tool.
Use clutch adjustment screwdriver supplied with the tool.
•
Straight tool con gurations must be mounted using approved mounting ange or reaction bar as speci ed in Parts Information
•
Manual 16601072.
For additional information refer to Product Safety Information Manual Form 04585006.
Manuals can be downloaded from ingersollrandproducts.com
Product Speci cations
Style
QA6AA-030
QA6AA-040
QA6 QA6AA-055
QA6AA-070
QA6AA-090
QA8AA-040
Angle, Lever Start QA8AA-055
QA8AA-070
QA8AA-090
QA8
QA8AA-115
QA8AA-150
QA8AA-200
QA8AA-225
QA6AS-025
QA6AS-030
QA6
QA6AS-040
QA6AS-055
QA8AS-040
Straight, Lever Start QA8AS-055
QA8AS-070
QA8 QA8AS-090
QA8AS-115
QA8AS-150
QA8AS-180
16601064_ed5
Free Speed Clutch Torque Range
Model(s)
rpm
580
430
320
225
185
570
425
320
255
200
145
110
90
720
605
450
325
600
470
355
255
215
165
140
WARNING
Information given for tool operation at
Stall Torque
Nm Nm
15-30 39
20-40 49
25-55 65
35-70 88
45-90 103
20-40 52
25-55 68
35-70 86
45-90 108
70-115 124
75-150 165
100-200 213
122-225 274
12-25 27
15-30 32
20-40 43
25-55 60
20-40 47
25-55 60
35-70 80
45-90 106
70-115 127
75-150 163
90-180 194
90 psi/6.2 bar
Recommended Operating Max. Torque
Nm
30
40
55
70
90
40
55
70
90
115
150
200
225
25
30
40
55
40
55
70
90
115
150
180
EN
EN-1