Risk Of Electric Shock - Parkside PPS 30 B2 Originalbetriebsanleitung

remove it from the holder after
allowing it to cool down for
15 minutes.
Hot metal and sparks are blown
off from the cutting arch. The
flying sparks, hot metal as well as
hot objects and hot device equip-
ment can cause fires or burns.
Check the working environment
and make sure the workplace is
suitable prior to using the device.
Remove all flammable material
„
within 10 m of the plasma
cutter. If this is not possible,
cover the objects meticulously
using suitable covers.
Do not make cuts in places
„
where flying sparks could
come into contact with flamma-
ble material.
Protect yourself and others
„
from flying sparks and hot
metal.
Please be careful because
„
sparks and hot materials can
easily fall through small gaps
and openings while cutting
and land on adjacent areas.
Please be aware that cut-
„
ting on a ceiling, floor or a
partition can cause a fire on
the opposite side that is not
visible.
Connect the power cable using
„
the shortest route with a socket
situated close to the workplace
10
GB/IE/NI
to prevent the power cable
from being spread across the
whole room and located on a
surface which could cause an
electric shock, sparks or fire
outbreak.
Do not use the plasma cutter to
„
defrost frozen tubes.

Risk of electric shock:

WARNING!
f Electric shock from the cutting
electrode can be fatal.
Do not use the plasma cutter
„
when it is raining or snowing.
Wear dry insulating gloves.
„
Do not touch the electrodes
„
with bare hands.
Do not wear wet or damaged
„
gloves.
Protect yourself from electric
„
shock with insulation against
the workpiece.
Do not open the device housing.
„
Additional protection against a
„
shock from the mains power in
the event a fault can be pro-
vided by using a fault-circuit
interrupter, which is operated
with a leakage current of no
more than 30 mA and covers
all mains-powered devices in
close proximity. The fault-circuit
interrupter must be suitable for
all types of current.