Plasma Cutting In Tight Spaces; Protective Clothing - Parkside PPS 30 B2 Originalbetriebsanleitung

z Plasma cutting in tight
spaces
When welding and plasma
cutting in tight spaces this may
pose a hazard through toxic
gases (risk of suffocation). In tight
spaces the device may only be
operated if there are trained indi-
viduals in the immediate vicinity
who can intervene if necessary.
In this case, before starting to
use the plasma cutter, an expert
must carry out an assessment in
order to determine what steps
are necessary, in order to guar-
antee safety at work and which
precautionary measures should
be taken during the actual cutting
procedure.
z Total of no­load voltages
When more than one plasma
power source is operated at the
same time, their no-load voltages
may add up and lead to an
increased electrical hazard.
The plasma power sources must
be clearly marked with their
individual control units and
connections, in order to be able
to identify which device belongs
to which circuit.
z Using shoulder straps
The plasma cutter must not be
used if the device is being
carried e.g. with a shoulder strap.
This is intended to prevent:
The risk of losing your balance
„
if the lines or hoses which are
connected are pulled.
The increased risk of an
„
electric shock as the operator
comes into contact with the
earth if he/she is using a
Class I plasma cutter, the
housing of which is earthed
through its conductor.
z Protective clothing
At work, the operator must
„
protect his/her whole body by
using appropriate clothing and
face protection against radia-
tions and burns. The following
steps must be observed:
– Wear protective clothing
prior to cutting work.
– Wear gloves.
– Open windows to guarantee
air supply.
– Wear protective goggles.
Gauntlet gloves made of a
„
suitable material (leather) must
be worn on both hands. They
must be in perfect condition.
13
GB/IE/NI