Maintenance; Storage; Information About Recycling And Disposal - Parkside PPS 30 B2 Originalbetriebsanleitung

The burner sleeve 8c
central bore is damaged or if it has
expanded in comparison to the bore of a
new nozzle. If the electrode
sleeve 8c are replaced too late, this can
result in the parts overheating.
Once replaced, make sure the nozzle
clamping sleeve
8b
sufficiently.
ATTENTION!
fThe nozzle clamp sleeve
be screwed on to the burner
has been fitted with the electrode
8c
burner sleeve .
fIf these parts are missing, the de­
vice may malfunction and it may
create a hazard for the operating
personnel.

• Maintenance

NOTE!
fThe plasma cutter must be regularly
maintained for perfect function and to
comply with the safety requirements. Im-
proper and wrong operation may cause
failures and damage to the device. Have
repairs only conducted by qualified
specialists.
NOTE!
fIt is not necessary to empty the conden-
sation water container
collects here then fine droplets will form
under the container. The condensation
water is then dissipated through
evaporation.
20
GB/IE/NI
must be replaced if the
8d or the burner
is tightened
8b must only
8 once it
8d and
18 . If water
Switch off the main power supply and the
main switch of the device prior to carrying
out maintenance or repair work on the
plasma cutter.
Regularly clean the outside of the
„
plasma cutter and its accessories. Use
compressed air, cotton waste or a brush
to remove dirt and dust.
In case of a defect or a necessary
„
replacement of equipment parts, please
contact the appropriate qualified
personnel.

• Storage

If you will not be using the device for a
while, protect it from dust by storing it in a
clean and dry place.
• Information about recycling
and disposal
Don't throw away – recycle
Please return this device, accessories
and packaging to your local recy-
cling depot.
Please note the marking on the
packaging materials and separate
them as necessary. The packaging
materials are marked with abbreviations (a)
and digits (b) with the following definitions:
1–7: Plastics, 20–22: Paper and cardboard,
80–98: Composite materials.
According to European Directive
2012/19/EU, used electrical devices must
be collected separately for environmentally
compatible recycling or recovery.
Please return this device to an approved