Parkside PPS 30 B2 Originalbetriebsanleitung Seite 12

There must be means of rapid
„
electrical isolation of the
cutting power source or the
cutting circuit (e.g. emergency
stop device) which are easily
accessible.
Danger from smoke emis­
sion when plasma cutting:
Inhalation of fumes which
„
result from plasma cutting can
endanger health.
Do not keep your head in the
„
fumes.
Use the device in open areas.
„
Only use the device in
„
well-ventilated spaces.
Danger from flying sparks
when plasma cutting:
Cutting sparks can cause an
„
explosion or fire.
Keep flammable substances
„
away from the cutting location.
Do not use the plasma cutter
„
near flammable substances.
Cutting sparks can cause
„
fires.
Keep a fire extinguisher close
„
by and an observer should
be present to be able to use it
immediately.
Do not carry out plasma
„
cutting on drums or any other
closed containers.
Danger from arc beams:
Arc beams can damage your
„
eyes and injure your skin.
Wear a hat and safety
„
goggles
Wear hearing protection and
„
high, closed shirt collars.
Use a welding safety helmet
„
and make sure that the filter
setting is correct.
Wear complete body
„
protection.
Danger from electro­
magnetic fields:
Cutting current generates
„
electromagnetic fields.
Do not use if you have a
„
medical implant.
Never wrap the cutting cable
„
around your body.
Guide cutting cables together.
„
z Welding mask­specific
safety instructions
With the help of a bright light
„
source (e.g. lighter) examine
the proper functioning of the
welding shield prior to starting
with any cutting work.
Cut spatters can damage the
„
protective screen. Immediately
replace damaged or scratched
protective screens.
11
GB/IE/NI