Energy Saving - Nuova Simonelli pronto bar Gebrauchsanleitung

4.7 RINSE GROUP
It can be set to ON/OFF. If set on ON, the machine
will carry out a rinsing cycle of the group 20 minutes
after the last cycle if the machine is not being used.
By pressing the ENTER key
be accessed; keys
ON-OFF.
Press ENTER to confirm the setting, then press
the RESET key to exit the submenu.
4.8 WASHING WARNING (Wash alarm cycles)
Pressing ENTER
sub menu. This programmes the number of cycles
after which the group wash warning is displayed.
The keys are used to increase/decrease
the number of cycles for viewing the group wash
message (min. 50 – max. NO LIMIT). Press
to confirm settings.
the submenu.
4.9 MILK CLEAN WARNING
(Milk clean warning)
Pressing ENTER it is possible to enter the sub
menu. This programmes the number of hours from
the last milk beverage being dispensed, after which
the cappuccino maker cleaning warning is displayed.
The keys are used to increase / decrease
the number of hours before the cappuccino maker
clearing message is displayed (min. NO LIMIT – max.
12H). Press ENTER
RESET to quit the submenu.
4.10 PROG ON OFF (Programming automatic
switch on/off)
This is to programme the automatic ON/OFF times
for the machine. The default setting is for the
machine to be set to "STANDBY" every day of the
week and therefore, it needs to be switched on/ off
using the ON/OFF key.
Pressing ENTER it is possible to enter the sub
52
the submenu can
allow you to select
it is possible to enter the
ENTER
Press RESET to quit
to confirm settings. Press
menu and the display will read as follows:
SUNDAY
DAY OFF
The keys are used to view the settings for
each day of the week. Press
required day of the week; the
used to select the hour and minutes for switching on
and the hour and minutes for switching off.
SUNDAY
ON 00:00 OFF 00:00
Press ENTER to confirm, scroll through
the menu using the

4.11 ENERGY SAVING

This is used to set the time after which the machine
enables the energy-saving device, while still keeping
the water tank at working temperature.
Press the ENTER
1 Hours:Minutes
Use the keys to increase / decrease the
time after which the ENERGY-SAVING function is
enabled by 30-minute intervals. This function is deac-
tivated if the timer is left at zero.
to confirm the setting and then press
to quit the sub menu.
4.12 DAY HOUR
This programmes the day, hour and minutes, which
will be shown on the machine display.
Pressing ENTER it is possible to enter the sub
menu; the keys
the minutes required.
EN
ENTER to set the
keys are
to quit the submenu.
key to access the submenu.
Press ENTER
RESET
keys are used to choose