Programming In User Mode; Programming In Service Engineer Mode - Nuova Simonelli pronto bar Gebrauchsanleitung

EN
7. PROGRAMMING
7.1 ENTERING THE
PROGRAMMING MODE
With the machine switched on, hold down the
ENTER key (for about 5 seconds) until the first
program function appears.
LANGUAGE LANGUAGE
The keys available during the programming stage
are:
ENTER key:
CURSORS keys: To scroll through the
RESET keys:
LIST OF PROGRAMMABLE FUNCTIONS
Functions that can be accessed from the USER and
TECHNICIAN modes.
1. LANGUAGE (LANGUAGE SELECTION)
Functions that can "ONLY" be accessed from the
TECHNICIAN mode.
2.
COUNTERS
3.
PROGRAM DOSES
4.
SETTING
5.
EXIT
To enter the menu and/or
confirm the setting.
menu and increase/
reduce settings.
To go back to the previous
step.
7.2 PROGRAMMING IN
USER MODE
1 . LANGUAGE
(LANGUAGE SELECTION)
Press the ENTER
menu. This serves to set the language for the
machine/operator interface, which is shown
on the display.
Press the keys to select the required
language.
The possible languages are as follows: ENGLISH,
ITALIANO, FRANCAIS, DEUTSCH, ESPANOL.
Press RESET
Press RESET
function.
7.3 PROGRAMMING IN
SERVICE ENGINEER MODE
To access the functions that can only be programmed
in SERVICE ENGINEER MODE, press the up arrow
key from the LANGUAGE menu and the display
will read as follows:
PASSWORD
_ _ _ _ _
Enter the correct password to access the first item
on the programming menu that can be accessed in
SERVICE ENGINEER MODE.
The default PASSWORD setting is 5 times the "2"
key.
key to access the sub-
to leave the submenu.
to quit the programming
47