Troubleshooting; Possible Cause - Scheppach 5906706901 Originalbetriebsanleitung

Improper handling of waste equipment may have
negative consequences for the environment and hu-
man health due to potentially hazardous substances
that are often contained in electrical and electron-
ic equipment. By properly disposing of this product,
you are also contributing to the effective use of nat-
ural resources. You can obtain information on collec-
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.

17. Troubleshooting

The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equipment
fails to work properly. If the problem still persists after working through the list, please contact your nearest service work-
shop.
Fault
Diamond cutting disc comes off
when motor is deactivated.
When motor is deactivated.
Motor has no output

Possible cause

Fastening nut not tightened properly
Failure of mains circuit-breaker
Extension cable defective
Connection with motor or switch is not OK
Motor or switch Is defective
Cross-section of the extension cable Is not
sufficient
Overloading
www.scheppach.com
Remedy
Tighten fastening nu
Check mains circuit-breaker
Replace extension cable
Have it checked by an electrician
Have it checked by an electrician
See electrical connection, the fuse has
blown
Check tool
GB | 27