Cleaning Accessories; Cleaning The Control Panel; Cleaning The Inside Of The Oven (Cooking Area) - Grundig GEKW19400DX Benutzerhandbuch

Glass surfaces
• When cleaning glass surfaces, do not use
hard metal scrapers and abrasive cleaning
materials. They can damage the glass sur-
face.
• Clean the appliance using dishwashing
detergent, warm water and a microfiber
cloth specific for glass surfaces and dry it
with a dry microfiber cloth.
• If there is residual detergent after cleaning,
wipe it with cold water and dry with a
clean and dry microfiber cloth. Residual
detergent may damage the glass surface
next time.
• Under no circumstances should the dried-
up residue on the glass surface be
cleaned off with serrated knives, wire wool
or similar scratching tools.
• You can remove the calcium stains (yellow
stains) on the glass surface with the com-
mercially available descaling agent, with a
descaling agent such as vinegar or lemon
juice.
• If the surface is heavily soiled, apply the
cleaning agent on the stain with a sponge
and wait a long time for it to work properly.
Then clean the glass surface with a wet
cloth.
• Discolorations and stains on the glass sur-
face are normal and not defects.
Plastic parts and painted surfaces
• Clean plastic parts and painted surfaces
using dishwashing detergent, warm water
and a soft cloth or sponge and dry them
with a dry cloth.
• Do not use hard metal scrapers and ab-
rasive cleaners. They may damage the
surfaces.
• Ensure that the joints of the components
of the product are not left damp and with
detergent. Otherwise, corrosion may occur
on these joints.

7.2 Cleaning Accessories

Do not put the product accessories in a
dishwasher unless otherwise stated in the
user's manual.

7.3 Cleaning the Control Panel

• When cleaning the panels with knob-con-
trol, wipe the panel and knobs with a
damp soft cloth and dry with a dry cloth.
Do not remove the knobs and gaskets un-
derneath to clean the panel. The control
panel and knobs may be damaged.
• While cleaning the inox panels with knob
control, do not use inox cleaning agents
around the knob. The indicators around
the knob can be erased.
• Clean the touch control panels with a
damp soft cloth and dry with a dry cloth. If
your product has a key lock feature, set
the key lock before performing control
panel cleaning. Otherwise, incorrect de-
tection may occur on the keys.
7.4 Cleaning the inside of the oven
(cooking area)
Follow the cleaning steps described in the
"General Cleaning Information" [} 45] section
according to the surface types in your oven.
Cleaning the side walls of the oven
The side walls in the cooking area can only
be covered with enamel or catalytic walls. It
varies by model. If there is a catalytic wall,
refer to the "Catalytic surfaces" [} 45] section
for information.
If your product is a wire shelf model, remove
the wire shelves before cleaning the side
walls. Then complete the cleaning as de-
scribed in the "General Cleaning Informa-
tion" [} 45] section according to the side wall
surface type.
To remove the side wire shelves:
a. Hold the side wire shelf at the bottom.
Pull it down and free it from the bottom
slots.
b. Pull the side wire shelf in the opposite dir-
ection of the side wall.
c. Completely remove the side wire shelf by
pulling it up.
EN / 46